Electrolux 400 SERIES Manuel d'utilisation et d'entretien - Page 25
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Electrolux 400 SERIES. Electrolux 400 SERIES 28 pages. Front load dryer
Également pour Electrolux 400 SERIES : Manuel d'utilisation et d'entretien (16 pages), Manuel d'utilisation et d'entretien (39 pages), Manuel d'instructions d'installation (50 pages), Manuel d'utilisation et d'entretien (46 pages)
Imprimer la page
Solutions to Common Inquiries
PROBLEM POSSIBLE CAUSES
Drying
• Lint filter is clogged with lint.
cycle takes
too long,
outside of
• Exhaust duct requirements
the dryer
have not been met.
feels too
hot or
smells hot.
• Electric dryer is connected to
a 208 volt circuit.
• Drying procedures have not
been followed.
• Outside exhaust hood or
exhaust duct may be clogged
or restricted.
• High humidity.
Excess
• Exhaust damper stuck open
moisture
or not present.
in drum
between
cycles.
Excessive
• Dryer is overloaded.
wrinkling.
• Items left in dryer too long.
• Insufficient sorting of items.
• Drying temperature too high.
• Drying load is very small.
Scratching
• Foreign objects such as
or chipping
coins, pins, clips or buttons
of the drum
are inside the dryer.*
finish.
• Permanently attached items
such as belt buckles, zippers
and fasteners may be hitting
the inside of the drum.*
* Drum damage caused by foreign objects or permanently attached
items is not covered by the warranty
SOLUTIONS
• Make sure all lint has been removed
from the dryer lint filter before start-
ing each cycle.
• Exhaust duct must be at least 4
inches in diameter and made of rigid
or semi-rigid metal.
• When in place, the duct must not
exceed length listed in the Installation
Instructions .
• Drying time will be 20% longer than
drying on a 240 volt circuit.
• See Operating Instructions .
• Clean out any obstruction.
• Use a dehumidifier near the dryer.
• Fix or clean the damper, or install
new one.
• DO NOT overload. See Operating
Instructions .
• Remove items as soon as cycle
ends.
• See Operating Instructions .
• Follow fabric care label instructions.
• Add two or three larger items.
• Always remove foreign objects from
pockets before laundering. Remove
objects from drum and restart dryer.
• It may be necessary to sew a
scrap of material securely around
ornaments before drying to prevent
scratching and damage to the dryer.
.
25