Common Sense RC ACDC-6 Manuel d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Common Sense RC ACDC-6. Common Sense RC ACDC-6 8 pages. 6s balancing charger

Imprimer la page
Common Sense RC ACDC-6 Manuel d'utilisation
Dec. / Inc.
5.3.2 According to press
voltage of each batteries and final voltage etc. continually as follow
(this need to connect the balance plug):
Inc.
You can check the individual voltages of each cell in the battery
4.20
4.20
4.20
pack while using the individual connection cable to the battery.
0.00
0.00
0.00
End
Voltag
The final voltage will be reached at the end of process
AUTO CHK
Dec.
Capacity Cut-
o
You can inquire the safety capacity
ON
5000mAh
Dec.
Sa
ty
tim r
You can
inquire
ON
120min
Dec.
You can use the 3-pin port as an USB port or
USb/T mp
S l ct
T mp Cut-
o
80C
temperature value
Dec.
It shows
EXT.T mp
0C
sersor is connected you can inqrire
Dec.
IN Pow r VOLTAGE
This shows the present voltage of input power
12.60V
8
key you can inquire the individual
the safety time
inquire
you
the external temperature when the temperature
A2
shows the trigger voltage for automatic charge te r m in a tio n of NiMH and
A1
NiCd battery (△V), the effective value ranges from 5 to 20mV per cell. If △V is set
hig er, there is a danger of overchargein g the batter y ; if it is set lo wer, there is a
p o s s ib ili t y o f p r e m a t u r e t e r m in atio n. ple ase refer technic al specif ic atio n of the
battery.(NiCd: 12mV,NiMH:7mV)
Tips：If the voltage of charging battery is lower than 2.5V, △V may can not be perceived,
this will cause a danger of discharge.You can connect a temperature sensor or use the charger
current above 1C to avoid it.
There is a
3-pin port on the left side of the unit . It can be used as a temperature
sensor port or USB port, If the port is assig ned a s a t e m p . port, you can use an
optional temperature probe to contact the surface of battery(see the screen
and you can set the maximum temperature at which the danger should allo w battery
t o r e a c h d u r in g c h a r g e , o n c e a b a t t e r y r e a c h e s t h is v a lu e t h e process will be
terminated to protect the battery. When it is selected as an USB port, you can connect
the charger to your PC with an optional USB cable. this can utilize the optional software
that can show you the charge process at PC. (see the screen
When
NiMH or NiCd battery is on the cyclic process of charge/discharge,it c a n
often become warm . The program insert a time delay to occur after each charge and
dis charge process to allow the battery adequate time to cool down before b e in g
s u b je c t e d t o t h e n e x t p r ocess. (see the screen
minutes.If you are not sure,you can set it over 10 minutes.
The charger will automatically supply the trickle function to achieve the full charge
with out overheating the battery after fast charge has been teminated.you can alter
the trickle value when the charger shows you the screen
When you start a charge process, the integral safety timer automatically starts
running at the same time.this is programmed to prevent overcharge the battery if it
proves to be faulty,or if the termination circuit cannot detect the battery full.
shows you this program can be on or off,and you can set the maximum safety time,
the value ranges from 10 to 720min. As the same principle,there is a maximum-cap
acity-limited function. See
At the screen
W h e n y o u u s e t h e c a r b a tte r y to s u p p l y p o w e r fo r c h a rg e r, s c r e e n
y o u th i s p r o g r a m monit ors the voltage of input DC battery. If the voltage drops below the
value you set the operation forcibly terminated to protect the input battery.
the safety
You can adjust the brightness of LCD screen at the charger(see
Please refer the information below(chart A)，and select the correct parameter
for each battery, or it will cause a serious result!
iterm
Standard volta ge
(V/cell)
Max. Charge
volta ge cut off
level (V/cell)
Allo wable fast
current
Min.Discharge
volta ge cut off
level (V/cell)
A5
, the value ranges from 10 to 20000mAh.
A8
you can set the audible sounds to be on or off by this program.
A9
ty pes
Li-P o
Li-1 0
Li-F e
NiM H
3.7 0
3.6 0
3.3 0
4.2 0
4.10
3.60
1C
1C
4C
3.00
3.00
2.00
A3
)
A3
)
A4
A4
) the value ranges from 1 to 60
A6
A7
s h o w s
A10
)
A11
chart A
NiC D
Pb
1.2 0
1.2 0
2.0 0
1.60
1.60
2.45
2C
2C
0.4C
1.00
0.85
1.75
5