ATI Technologies 39-0220 Fonctionnement - Page 6

Parcourez en ligne ou téléchargez le pdf Fonctionnement pour {nom_de_la_catégorie} ATI Technologies 39-0220. ATI Technologies 39-0220 15 pages.

Select Antenna and Check Voltage Levels:
This subroutine allows a specific stall and antenna to be selected; the system will activate the antenna continuously
and, if an ear tag is within reading distance, the MicroMarque3S buzzer will sound.
Checking the Voltage Levels.
Connect a high quality voltmeter set to the 200v DC range across the Voltage Test Points on the Bank
Distribution Board on the Auto-ID Interface (see Page (10). Ensure the polarity is correct.
Reset the MicroMarque3S.
Run Subroutine 305. The code 'tESt Ant' (Test Antenna) will appear in the Cow Number window, the side will
default to the 'reset' side and the stall to number 1. That antenna is now active
.
The voltmeter should read in the range 90 to 180 volts DC.
Slowly turn the tuning knob on the tuning module- it turns in bothdirections- until the highest
voltage is achieved. If it is not possible to achieve a voltage level higher than 90 volts, please
contact your supplier.
It is only necessary to carry out the tuning process once. Do not repeat for the left hand side of
the parlour.
Press Reset to exit the subroutine.
!
Check the antenna range
at every stall
Antenna Voltage Test Points
1 1 3
VOLTS DC
Subroutine 305:
Cow
Program
DANGER
High Voltage
Shock Hazard
Bank Distribution Board
+
-
HERRINGBONE
AUTO-ID
OPERATION: 3
RESET
Cancel
Shift
MASTITIS
3
SUBS
Enter
Ration
Yield/Flags
Tuning Module
Turn knob slowly to tune to highest voltage
+
SUBS
Enter
TEST
0
5
RESET
Cancel
Stall/Side
DELETE
Change