ATI Technologies 39-0220 Операційна діяльність - Сторінка 6

Переглянути онлайн або завантажити pdf Операційна діяльність для Промислове обладнання ATI Technologies 39-0220. ATI Technologies 39-0220 15 сторінок.

Друкувати сторінку

Select Antenna and Check Voltage Levels:

This subroutine allows a specific stall and antenna to be selected; the system will activate the antenna continuously

and, if an ear tag is within reading distance, the MicroMarque3S buzzer will sound.

Checking the Voltage Levels.

Connect a high quality voltmeter set to the 200v DC range across the Voltage Test Points on the Bank

Distribution Board on the Auto-ID Interface (see Page (10). Ensure the polarity is correct.

Reset the MicroMarque3S.

Run Subroutine 305. The code 'tESt Ant' (Test Antenna) will appear in the Cow Number window, the side will

default to the 'reset' side and the stall to number 1. That antenna is now active

The voltmeter should read in the range 90 to 180 volts DC.

Slowly turn the tuning knob on the tuning module- it turns in bothdirections- until the highest

voltage is achieved. If it is not possible to achieve a voltage level higher than 90 volts, please

contact your supplier.

It is only necessary to carry out the tuning process once. Do not repeat for the left hand side of

the parlour.

Press Reset to exit the subroutine.

Check the antenna range

at every stall

Antenna Voltage Test Points

1 1 3

VOLTS DC

Subroutine 305:

Cow

Program

DANGER

High Voltage

Shock Hazard

Bank Distribution Board

HERRINGBONE

AUTO-ID

OPERATION: 3

RESET

Cancel

Shift

MASTITIS

SUBS

Enter

Ration

Yield/Flags

Tuning Module

Turn knob slowly to tune to highest voltage

SUBS

Enter

TEST

RESET

Cancel

Stall/Side

DELETE

Change