ATI Technologies QC-210 Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ATI Technologies QC-210. ATI Technologies QC-210 17 pages. Tool changer

Manual, Robotic Tool Changer Third Generation Teaching Aids

Document #9610-20-3370-02

1.3 Safety Precautions

DANGER: The gap between the Master and Tool sides as well as the gap between

the Master plate and Master side teaching aid are pinch points. Physical contact in

these pinch points will result in serious or permanent injury to personnel. All personnel

should be prevented from placing any body part or clothing in the gap, especially during

actuation of the locking mechanism.

WARNING: During set-up and installation, the area between the Master and Tool

Teaching Aids must be kept clear. Failure to keep area clear will result in damage

to Tool Changer, Aids, modules, or end-of-arm tooling and could cause injury to

personnel.

WARNING: The Master and Tool teaching aids are only to be used with the Tool

Changer for intended applications and applications approved by the manufacturer.

Using these products in applications other than intended will result in damage to Tool

Changer, Teaching Aids, modules, or end-of-arm tooling and could cause injury to

personnel.

WARNING: Do not perform maintenance or repair(s) on the Tool Changer or modules

unless the Tool is safely supported or placed in the tool stand, all energized circuits

(e.g. electrical, air, water, etc.) are turned off, pressurized connections are purged

and power is discharged from circuits in accordance with the customer's safety

practices and policies. Injury or equipment damage can occur with the Tool not placed

and energized circuits on. Place the Tool in the tool stand, turn off and discharge all

energized circuits, purge all pressurized connections, and verify all circuits are de-

energized before performing maintenance or repair(s) on the Tool Changer or modules.

Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: 919.772.0115 • Fax: 919.772.8259 •

www.ati-ia.com

• Email: