ATI Technologies QC-210 매뉴얼 - 페이지 6

{카테고리_이름} ATI Technologies QC-210에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Technologies QC-210 17 페이지. Tool changer

ATI Technologies QC-210 매뉴얼
Manual, Robotic Tool Changer Third Generation Teaching Aids
Document #9610-20-3370-02

1.3 Safety Precautions

DANGER: The gap between the Master and Tool sides as well as the gap between
the Master plate and Master side teaching aid are pinch points. Physical contact in
these pinch points will result in serious or permanent injury to personnel. All personnel
should be prevented from placing any body part or clothing in the gap, especially during
actuation of the locking mechanism.
WARNING: During set-up and installation, the area between the Master and Tool
Teaching Aids must be kept clear. Failure to keep area clear will result in damage
to Tool Changer, Aids, modules, or end-of-arm tooling and could cause injury to
personnel.
WARNING: The Master and Tool teaching aids are only to be used with the Tool
Changer for intended applications and applications approved by the manufacturer.
Using these products in applications other than intended will result in damage to Tool
Changer, Teaching Aids, modules, or end-of-arm tooling and could cause injury to
personnel.
WARNING: Do not perform maintenance or repair(s) on the Tool Changer or modules
unless the Tool is safely supported or placed in the tool stand, all energized circuits
(e.g. electrical, air, water, etc.) are turned off, pressurized connections are purged
and power is discharged from circuits in accordance with the customer's safety
practices and policies. Injury or equipment damage can occur with the Tool not placed
and energized circuits on. Place the Tool in the tool stand, turn off and discharge all
energized circuits, purge all pressurized connections, and verify all circuits are de-
energized before performing maintenance or repair(s) on the Tool Changer or modules.
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: 919.772.0115 • Fax: 919.772.8259 •
www.ati-ia.com
6
• Email: