Ativa 8022567 Manuel de l'utilisateur - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Ativa 8022567. Ativa 8022567 13 pages. Dect 6.0 cordless phone with answering macine & speakerphone
- 1. Getting Started
- 2. Installation
- 3. Getting to Know Your Phone
- 4. Handset Overview
- 5. Redial Button
- 6. Additional Handsets
- 7. Personal Settings
- 8. Clock and Alarm
- 9. Advanced Settings
- 10. Using the Answering Machine (TAM)
- 11. Troubleshooting Guide
- 12. General Product Care
- 13. Important Safety Instructions
Introduction
CAUTION: When using telephone equipment, there are basic safety instructions that should always be followed.
Refer to the Import safety instructions section in this book and save them for future reference.
This WPS01 Cordless phone is compliant with the DECT 6.0 standard which operates in the 1.92GHz to
1.93GHz frequency range.
IMPORTANT: Because cordless phones operate on electricity, you should have at least one phone in your home that isn't
cordless, in case the power in your home goes out.
Getting Started
Package Contents
Make sure your package includes the items shown here.
Telephone Base Unit
1 Cordless Handset
AC Adapter
Telephone Line Cord
2 Rechargeable AAA Ni-MH Batteries (1.2V, 300mAh)
User Manual
Installation
Important Installation Guidelines
• Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens, heating
appliances and direct sunlight.
• Avoid areas of excessive dust, moisture and low temperature.
• Avoid other cordless telephones or personal computers.
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
• Never touch non-insulated telephone wires or terminals, unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
Installing the telephone base
The telephone base should be placed at least 1 meter away from other electrical appliances in order
to avoid interference. The handset exchanges radio signals with the telephone base. The strength of
these signals depends on the position of the base. You can obtain a stronger signal by placing the
base higher.
Operating range of the handset
The operating range of your telephone is 300 meters outdoors without obstructions between the
telephone base and handset. Obstructions reduce the operating range. When the telephone base is
located indoors, while the handset is indoors or outdoors, the operating range is reduced to 50 meters.
Thick concrete walls reduce the operating range significantly.
Signal strength
When the handset is within the operating range of the telephone base,
the handset is out of range of range, the
base to turn off thisindicator.
1
appears on the screen. If
symbol flashes on the display.Get closer to the telephone
Installing and charging the batteries
Adapter Jack
1. Insert the plug of the supplied adapter to the back of the telephone base and the other end into an
electrical outlet.
2. Plug the telephone line cord to the back of the telephone base and the other end into a telephone wall
jack.
3. Insert the rechargeable Ni-MH batteries supplied into the handset by following the correct polarity as
indicated. Close the battery compartment.
4. Place the handset on the telephone base and let the batteries charge for 24 hours before using it for the
first time.
Low battery warning
When the batteries are very low,
flashes onthe handset screentoprompt you torechargethe
batteries.
Battery performance
When fully charged, the batteries offer approximately 9 hours of talk time and 100 hours of standby time
under ideal conditions. Please note that a new battery reaches its full capacity after several days of normal use.
The battery capacity decreases over time, reducing the talk time and standby time. Replace the batteries if
necessary.
The batteries and the handset will become hot during charging. This is normal.
Tip
When you are not using your handset, place it on the charger so that you can always have fully charged
batteries.
Telephone Jack
2