Ativa 8022567 Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Telefon bezprzewodowy Ativa 8022567. Ativa 8022567 13 stron. Dect 6.0 cordless phone with answering macine & speakerphone

Drukuj stronę

Introduction

CAUTION: When using telephone equipment, there are basic safety instructions that should always be followed.

Refer to the Import safety instructions section in this book and save them for future reference.

This WPS01 Cordless phone is compliant with the DECT 6.0 standard which operates in the 1.92GHz to

1.93GHz frequency range.

IMPORTANT: Because cordless phones operate on electricity, you should have at least one phone in your home that isn't

cordless, in case the power in your home goes out.

Getting Started

Package Contents

Make sure your package includes the items shown here.

Telephone Base Unit

1 Cordless Handset

AC Adapter

Telephone Line Cord

2 Rechargeable AAA Ni-MH Batteries (1.2V, 300mAh)

User Manual

Installation

Important Installation Guidelines

• Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens, heating

appliances and direct sunlight.

• Avoid areas of excessive dust, moisture and low temperature.

• Avoid other cordless telephones or personal computers.

• Never install telephone wiring during a lightning storm.

• Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

• Never touch non-insulated telephone wires or terminals, unless the telephone line has been

disconnected at the network interface.

• Use caution when installing or modifying telephone lines.

Installing the telephone base

The telephone base should be placed at least 1 meter away from other electrical appliances in order

to avoid interference. The handset exchanges radio signals with the telephone base. The strength of

these signals depends on the position of the base. You can obtain a stronger signal by placing the

base higher.

Operating range of the handset

The operating range of your telephone is 300 meters outdoors without obstructions between the

telephone base and handset. Obstructions reduce the operating range. When the telephone base is

located indoors, while the handset is indoors or outdoors, the operating range is reduced to 50 meters.

Thick concrete walls reduce the operating range significantly.

Signal strength

When the handset is within the operating range of the telephone base,

the handset is out of range of range, the

base to turn off thisindicator.

appears on the screen. If

symbol flashes on the display.Get closer to the telephone

Installing and charging the batteries

Adapter Jack

1. Insert the plug of the supplied adapter to the back of the telephone base and the other end into an

electrical outlet.

2. Plug the telephone line cord to the back of the telephone base and the other end into a telephone wall

jack.

3. Insert the rechargeable Ni-MH batteries supplied into the handset by following the correct polarity as

indicated. Close the battery compartment.

4. Place the handset on the telephone base and let the batteries charge for 24 hours before using it for the

first time.

Low battery warning

When the batteries are very low,

flashes onthe handset screentoprompt you torechargethe

batteries.

Battery performance

When fully charged, the batteries offer approximately 9 hours of talk time and 100 hours of standby time

under ideal conditions. Please note that a new battery reaches its full capacity after several days of normal use.

The battery capacity decreases over time, reducing the talk time and standby time. Replace the batteries if

necessary.

The batteries and the handset will become hot during charging. This is normal.

Tip

When you are not using your handset, place it on the charger so that you can always have fully charged

batteries.

Telephone Jack