Electrolux 316488524 Manuel d'installation, d'utilisation et d'entretien - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Electrolux 316488524. Electrolux 316488524 20 pages. 30” and 36” free-standing range hood

Imprimer la page
Electrolux 316488524 Manuel d'installation, d'utilisation et d'entretien
Installing the hood
12
12
12
12
12

Making the electrical connections

Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 V
120 V
AC, 15 or 20 Amp cir
AC, 15 or 20 Amp cir
120 VAC, 15 or 20 Amp cir
120 V
120 V
AC, 15 or 20 Amp cir
AC, 15 or 20 Amp circuit r
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
Failur
Failur
e to do so can r
e to do so can r
Failur
Failur
Failure to do so can r
e to do so can r
e to do so can result in death or electrical
shock.
shock.
shock.
shock.
shock.
• Remove junction box cover and knockout on the
top left side.
cuit r
cuit r
equir
equir
ed.
ed.
cuit requir
cuit r
equired.
equir
ed.
ed.
esult in death or electrical
esult in death or electrical
esult in death or electrical
esult in death or electrical
Knockout
Junction box
cover
• If not already done, install 1/2" conduit connector
in j-box.
House
wiring
U.L. listed
wire nut
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2" conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done while always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover and reapply screws.
Metal electrical
conduit