Electrolux CH 910 Manuel de l'utilisateur - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Electrolux CH 910. Electrolux CH 910 28 pages. Stylish stainless steel chimney hood
Également pour Electrolux CH 910 : Manuel d'instruction (21 pages)
Imprimer la page
Before carrying out any maintenance
or cleaning isolate the cooker hood
from the mains supply.
Charcoal Filters
In the recirculation mode the charcoal
fi lters absorb smells and unwanted
odours.
Enabling the alarm signal
• In
Recirculation
the Filter saturation Alarm must be
enabled at the time of installation or
later.
• Switch off the lights and the motor.
• Disconnect the mains power supply
to the hood by removing the motor
unit power supply cable connector,
switching off the power supply at the
Mains or turning the Main switch off.
• Restore the connection, pressing and
holding T2.
• Release the touch control, touch
controls L, T2 and F will light up
normally.
• Within 3 seconds press the touch
control F until the key itself fl ashes to
confi rm as follows:
•2 fl ashes – Charcoal odour Filter
saturation Alarm ENABLED
•1 fl ash - Charcoal odour Filter
saturation Alarm DISABLED
Version
Hoods,
MAINTENANCE AND CLEANING
This
fi lter
cannot
regenerated, and must be replaced when
the F touch control starts to fl ash, or at
least once every 4 months. The alarm is
only triggered when the motor is on.
To Remove/Replace the
Charcoal Filters
• Remove the metal grease fi lters
• Remove
the
carbon fi lter by releasing the fi xing
hooks
• Fit the new fi lter by hooking it into its
seating
• Replace the metal grease fi lters.
This appliance can be a possible fi re
hazard if the grease and charcoal fi l-
ters are not cleaned and replaced as
recommended.
Alarm signal reset
• Stop the motor.
• Press the touch control F for at least
4 seconds, until the touch control T1
fl ashes.
electrolux 9
be
washed
saturated
activated
or
EN