Electrolux CH 910 Kullanıcı Kılavuzu - Sayfa 9

Havalandırma Davlumbazı Electrolux CH 910 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electrolux CH 910 28 sayfaları. Stylish stainless steel chimney hood
Ayrıca Electrolux CH 910 için: Talimat Kitabı (21 sayfalar)

Sayfayı Yazdır

Before carrying out any maintenance

or cleaning isolate the cooker hood

from the mains supply.

Charcoal Filters

In the recirculation mode the charcoal

ﬁ lters absorb smells and unwanted

odours.

Enabling the alarm signal

• In

Recirculation

the Filter saturation Alarm must be

enabled at the time of installation or

later.

• Switch off the lights and the motor.

• Disconnect the mains power supply

to the hood by removing the motor

unit power supply cable connector,

switching off the power supply at the

Mains or turning the Main switch off.

• Restore the connection, pressing and

holding T2.

• Release the touch control, touch

controls L, T2 and F will light up

normally.

• Within 3 seconds press the touch

control F until the key itself ﬂ ashes to

conﬁ rm as follows:

•2 ﬂ ashes – Charcoal odour Filter

saturation Alarm ENABLED

•1 ﬂ ash - Charcoal odour Filter

saturation Alarm DISABLED

Version

Hoods,

MAINTENANCE AND CLEANING

This

ﬁ lter

cannot

regenerated, and must be replaced when

the F touch control starts to ﬂ ash, or at

least once every 4 months. The alarm is

only triggered when the motor is on.

To Remove/Replace the

Charcoal Filters

• Remove the metal grease ﬁ lters

• Remove

the

carbon ﬁ lter by releasing the ﬁ xing

hooks

• Fit the new ﬁ lter by hooking it into its

seating

• Replace the metal grease ﬁ lters.

This appliance can be a possible ﬁ re

hazard if the grease and charcoal ﬁ l-

ters are not cleaned and replaced as

recommended.

Alarm signal reset

• Stop the motor.

• Press the touch control F for at least

4 seconds, until the touch control T1

ﬂ ashes.

electrolux 9

washed

saturated

activated