Electrolux EFC 009 X Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Electrolux EFC 009 X. Electrolux EFC 009 X 16 pages. Electrolux cooker hood

Imprimer la page

Using the hood

The hood has one variable speed motor. For the

best performance, we recommend using the low

speeds in normal conditions and the high

speeds in particular cases of strong odour and

vapour concentration.

We recommend starting up the hood a few

minutes before cooking and keeping it running

until all the odours have been eliminated.

A – Motor OFF button

B – ON button and motor speed selection button 1 - 2 - 3 - 1 - 2 - . . . .

E – Speed 1 LED

F – Speed 2 LED and grease filter saturation LED (flashes)

C – Speed 3 LED and carbon filter saturation LED (flashes)

D – Intensive speed indicator LED

G – Intensive speed ON switch

H – OFF lamp button

I – ON lamp button

If the hood fails to operate correctly, briefly disconnect it from the mains power

supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once

more before contacting the Technical Assistance Service.

Intensive speed button

This speed should be used when the

concentration of cooking fumes or odours is

particularly strong (for example when frying,

cooking fish etc.).

The fast speed will run for about 5 minutes and

then return to the speed previously set automati-

cally (1, 2 or 3), or switch off if no speed was

selected. To turn off the fast speed, before the

end of the 5 minutes, press button A or button

Control devices for the grease

filter and carbon filter

This hood has a device which warns you when

to clean the grease filter or replace the carbon

filter (in the case of the air recircultion version).

This hood is delivered without a carbon filter.

For this reason the warning signal to replace the

carbon filter is not connected.

5 MIN

1 2 3

E F C D G

Important to know

If the hood is run at the same time as a burner

or fireplace that depend on ambient air (for

example gas, Diesel, coal or wood heaters,

water heaters, etc.) be careful, because the

hood, when it exhausts the air, removes the

ambient air required by the burner or fireplace

for combustion.

Not valid if the cooker hood is used in

recirculation mode.

If the hood will be used for recirculation of air,

with carbon filter, the warning signal have to be

connected as follows: Press the buttons B and G

at the same time for about 3 seconds. The LED

marked F lights up. When the LED marked C

lights up, the warning signal is connected.

To disconnect the warning signal, press the

buttons

B and G at the same time for about 3 seconds

until the LED marked C goes out.

Grease filter saturation led

The LED marked F warns you when the grease

filter needs to be cleaned.

This LED flashes to warn you that the grease

filters must be cleaned.

Generally, these must be cleaned after 40 hours

of use.

Read the maintenance instructions provided for

the grease filters.