Electrolux EFC 009 X Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Okap wentylacyjny Electrolux EFC 009 X. Electrolux EFC 009 X 16 stron. Electrolux cooker hood

Using the hood

Using the hood
The hood has one variable speed motor. For the
best performance, we recommend using the low
speeds in normal conditions and the high
speeds in particular cases of strong odour and
vapour concentration.
We recommend starting up the hood a few
minutes before cooking and keeping it running
until all the odours have been eliminated.
A – Motor OFF button
B – ON button and motor speed selection button 1 - 2 - 3 - 1 - 2 - . . . .
E – Speed 1 LED
F – Speed 2 LED and grease filter saturation LED (flashes)
C – Speed 3 LED and carbon filter saturation LED (flashes)
D – Intensive speed indicator LED
G – Intensive speed ON switch
H – OFF lamp button
I – ON lamp button
If the hood fails to operate correctly, briefly disconnect it from the mains power
supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once
more before contacting the Technical Assistance Service.

Intensive speed button

This speed should be used when the
concentration of cooking fumes or odours is
particularly strong (for example when frying,
cooking fish etc.).
The fast speed will run for about 5 minutes and
then return to the speed previously set automati-
cally (1, 2 or 3), or switch off if no speed was
selected. To turn off the fast speed, before the
end of the 5 minutes, press button A or button
B.
Control devices for the grease
filter and carbon filter
This hood has a device which warns you when
to clean the grease filter or replace the carbon
filter (in the case of the air recircultion version).
This hood is delivered without a carbon filter.
For this reason the warning signal to replace the
carbon filter is not connected.
5 MIN
0
1 2 3
F
C
A
B
E F C D G
Important to know
If the hood is run at the same time as a burner
or fireplace that depend on ambient air (for
example gas, Diesel, coal or wood heaters,
water heaters, etc.) be careful, because the
hood, when it exhausts the air, removes the
ambient air required by the burner or fireplace
for combustion.
Not valid if the cooker hood is used in
recirculation mode.
0
H
If the hood will be used for recirculation of air,
with carbon filter, the warning signal have to be
connected as follows: Press the buttons B and G
at the same time for about 3 seconds. The LED
marked F lights up. When the LED marked C
lights up, the warning signal is connected.
To disconnect the warning signal, press the
buttons
B and G at the same time for about 3 seconds
until the LED marked C goes out.

Grease filter saturation led

The LED marked F warns you when the grease
filter needs to be cleaned.
This LED flashes to warn you that the grease
filters must be cleaned.
Generally, these must be cleaned after 40 hours
of use.
Read the maintenance instructions provided for
the grease filters.
41
I
I