Atlantic Technology 3.1 HSB Manuel d'instruction - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Atlantic Technology 3.1 HSB. Atlantic Technology 3.1 HSB 12 pages. High performance front channel speaker base with powered h-pas subwoofer
Imprimer la page
Trouble Shooting Guide
Instruction Manual
Care of Your Speaker
Clean your cabinet using a soft, lint-free cloth. If you wish, you can slightly moisten
the cloth with plain water. Do not use any other cleaning agents or chemicals. Be care-
ful not to get any water on the driver cones or tweeter domes. After carefully removing
the grille from the speaker, gently clean it with a very slightly damp, lint-free cloth.
To remove the grille; gently pull the grille straight forward from the cabinet starting
at both ends working towards the middle until it is fully free from the cabinet. Do not
use a tool or pick as this may cause damage.
Troubleshooting Guide
Once your speaker base is set up, you should have many years of maintenance free
enjoyment from your system. However, if you should encounter a problem, refer to
the following guide to help you fi nd the solution. If a problem persists, you should
contact your local authorized Atlantic Technology dealer.
Problem
No output from Left, Center or Right
channel
No bass output
No bass or weak bass output
Audible buzz or hum
Possible Cause
Input wire dislodged.
Standby switch in the OFF position
AC power cord unplugged or plugged
into a non-working outlet.
Input cables not securely connected or
defective.
LEVEL control set too low.
Input cable not securely connected or
defective.
Ground loop through antenna or cable
TV system input.
Possible Solution
Reconnect wire and move speaker base away
from wall.
Move switch to either AUTO or ON position.
Plug into a working outlet.
Check all connections, then try another
input cable.
Turn LEVEL control up.
Check all connections, then try another
input cable.
Test by disconnecting antenna and/or cable
system input leads. If hum goes away, install
isolation balun(s) at that point.
9