Electrolux Icon E36WC45FSS Manuel d'utilisation et d'entretien Instructions d'installation - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien Instructions d'installation pour {nom_de_la_catégorie} Electrolux Icon E36WC45FSS. Electrolux Icon E36WC45FSS 24 pages. Electrolux e36wc45fss range hood: supplementary guide
Également pour Electrolux Icon E36WC45FSS : Fiche technique (2 pages), Catalogue des pièces d'usine (4 pages), Manuel d'utilisation et d'entretien (24 pages)
Imprimer la page
Getting Started
OPERATING YOUR HOOD
IMPORTANT
Do not operate the vent system without the filters in place or with dirty, grease-laden filters.
Controls
The hood is operated using the (5) push-buttons located at eye-level, on the front
edge of the hood.
The light switch turns the halogen lights on and off. Push the light switch once to
turn the lights ON - push a second time to turn the lights ON to a brighter level
- push a third time to turn the lights OFF.
The blower on-off / speed 1 switch turns the blower on to its
lowest running speed. To turn OFF the blower, push in and
hold this blower switch for approximately 2 seconds.
The blower speed 2 switch turns the blower on to medium-low
running speed. Pressing this switch a second time sets a timer
which keeps the blower operating at this speed for 10 minutes.
The LED will blink during this time and the blower will shut off
automatically.
The blower speed 3 and blower speed 4 switches operate the
same as blower speed 2 switch except:
Blower speed 3 is medium-high and blower speed 4 is high.
After every 30 hours of operation, the LED above the "blower
speed 1 switch" will be illuminated (RED) and blink for 30
seconds after turning off the blower. This is a reminder to
clean the grease filters. Once the grease filters are cleaned
and installed, press in and hold the "light switch" button for approximately 2
seconds during the blink of the LED.
9
Figure 1