Electrolux ICON E36WV100FS Manuel d'utilisation et d'entretien Instructions d'installation - Page 17
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien Instructions d'installation pour {nom_de_la_catégorie} Electrolux ICON E36WV100FS. Electrolux ICON E36WV100FS 24 pages. Electrolux ventilation hood installation instructions and use & care guide
Imprimer la page
INSTALLING THE ELECTRICAL
WARNING
Electrical wiring must be done by a qualified person(s) in accordance with all
applicable codes and standards. This range hood must be properly grounded.
Turn off electrical power at service entrance before wiring.
1 Run 120 VAC electrical power cable to the hoods wiring box.
2 Remove the cover from the wiring box and remove one knockout.
3 Feed 6" of cable through the knockout opening and secure the cable
to the wiring box with an appropriate connector.
4 Make electrical connections at the hood. Connect white-to-white, black-
to-black, and green-to-ground.
5 Replace the wiring box cover and screws. Make sure wires are not
pinched between the cover and box.
CONNECTING THE DUCTWORK
1 Install an adequate length of 8" diameter steel ducting to the range
hood's duct connector.
2 Connect the duct work between the range hood and duct leading to
the outside location.
3 Duct tape all joints to make them secure and air tight.
Installation
POWER CONNECTION AT HOOD
CONNECT:
WHITE-TO-WHITE
BLACK-TO-BLACK
GREEN-TO-GROUND
8" ROUND
DUCT
17
120 VOLT 60
HZ LINE-IN
Figure 12
Figure 13