ABSCO SHEDS 15151SK Manuel d'assemblage et d'instruction - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage et d'instruction pour {nom_de_la_catégorie} ABSCO SHEDS 15151SK. ABSCO SHEDS 15151SK 20 pages. N3/c1 frame kit
Également pour ABSCO SHEDS 15151SK : Manuel d'assemblage (20 pages)
Imprimer la page
BOXING FRAME SECTIONS
1. All frame sections have one side length of
38mm and another at 40mm.
3. Slide opposing sides together so that
each frame section fi ts neatly inside the
other.
5. Fix with tek screws.
Use tek screws to fi x the two sections and complete a boxed frame member as shown. Make sure that
you alternate tek screw position on opposing sides of the boxed sections. Align tek screws 296mm
apart. This is approximately 2 sheet corrugations in distance. If spaced correctly the screw heads will
line up with corrugations of the sheets and will make for a fl ush fi nish against the wall or roof.
NOTE:
- Only the horizontal wall frame sections are to be boxed.
- Do not screw any boxed sections until they have been correctly sized as the specific step instructs.
- Roof section, door frames and upright door studs are singular pieces.
- Use self drilling tek screws for all assembly and installation of these sections.
Absco Industries
Assembly Instruction Manual
N3/C1 FRAME KIT
FOR 1.5m WIDE TO
1.5m DEEP MODELS
Model: CYC15
2. Slide the 38mm side into the 40mm side
as shown.
4. Apply fi rm pressure to each side of the
boxed section to fi rmly lock it into position.
02/03/2021
1.0
7