3M G5 Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} 3M G5. 3M G5 10 pages. Drive-thru systems
Également pour 3M G5 : Manuel de référence rapide (2 pages), Bulletin technique (6 pages), Bulletin technique (2 pages), Manuel de démarrage rapide (3 pages), Bulletin technique (12 pages), Manuel (8 pages)

6. Re-wire any external button to change Order Taking Modes, SPLIT/CROSS, or DAY/NIGHT

Connect Use the following GPIOs to re-wire external buttons

Change Order Taking Modes

Split/Cross

Day/Night

7. Wiring to trigger Alert Messages

The Greeter functionality is built into the G5 Basestation Model G5B1. In addition to

• Playing back a Greet message to the customer at the Order Point and/or

• Playing a Reminder message at a scheduled time of day,

The user can also program the system to playback an Alert message whenever an external event occurs, such as Opening the Back

Door or Opening the Refrigerator.

You can configure any of the 16 GPIOs on the G5 Basestation Model as ALERT Message Trigger Inputs.

For example, if you chose to wire the back door sensor to GPIO7 and GND0, any time these two pins are shorted, the ALERT message

assigned to this input (such as Back Door Open) will play on each headset configured to play the ALERT Message.

See illustration below:

NOTE:

• Programming the G5 Basestation to play the Alert Message and

• Configuring which Headsets you want the G5 Basestation play this message on,

will be covered later in this document.

--- GPIO2 and GND0

--- GPIO1 and GND0

--- GPIO3 and GND0