3M G5 Bulletin technique

Parcourez en ligne ou téléchargez le pdf Bulletin technique pour {nom_de_la_catégorie} 3M G5. 3M G5 12 pages. Drive-thru systems
Également pour 3M G5 : Manuel de référence rapide (2 pages), Bulletin technique (6 pages), Bulletin technique (2 pages), Manuel (10 pages), Manuel de démarrage rapide (3 pages), Manuel (8 pages)

3M™ Drive-Thru Systems

3M™ Drive-Thru Basestation G5

Upgrading from 3M™ Wireless Communication System, Model XT-1 Basestation

to 3M™ Drive-Thru Basestation G5

Overview

This document describes and illustrates the steps involved to successfully replace a 3M™ Wireless Communication

System, Model XT-1 basestation with a 3M™ Drive-Thru Basestation G5, in sites using a single lane drive-thru

operation. For the remainder of the document:

• 3M™ Wireless Communication System, Model XT-1 basestation will be referred to as XT-1 Basestation, and

• 3M™ Drive-Thru Basestation G5 referred to as G5 Basestation.

Pre-Requisites

Interview the Store Manager and verify they are currently NOT experiencing any issues with their 3M Drive-Thru

equipment. If they are, these issues need to be resolved before conducting the Basestation upgrade.

2. Use the Pre-Installation Checklist to capture ALL information related to Store Operation and Greeter functionality

by:

• Checking and writing down the current settings from the XT-1 Basestation.

• Inspecting the XT-1 basestation for all connected peripherals (Timers, Greeters, External or Internal Vehicle

Detectors, Pre-Approach Loops, etc.).

• Interviewing the Store Manager for any desired changes in operation (such as OT Modes, Range, etc).

3. Verify the cable to the outside Order Post is in good condition.

4. Inspect the Order Post to verify the speaker and microphone are properly positioned in the order post and that

the 3M™ Acoustic Kit has been properly applied inside the order post.

Important Notes

The G5 Basestation allows for ONLY ONE internal Vehicle Detector Board per Lane (for the Order Point Loop).

If the current XT-1 Basestation has more than one Internal Vehicle Detector Board, ALL but one (the Vehicle

Detector Board connected to the Order Point) MUST be replaced with External Detectors.

2. The Greeter functionality is built into the G5 Basestation.

3. All G5 Basestation configurations will have to be manually entered either via the Basestation's Front Panel (Key-

pad and LCD Screen) or the Basestation's Web Server. Any Configuration File you may have exported from the

XT-1 Basestation CANNOT be imported/loaded onto the G5 Basestation.

Technical Bulletin #161 Release B

Technical Bulletin #161

Release B, January 2017