3M G5 Bulletin technique - Page 6

Parcourez en ligne ou téléchargez le pdf Bulletin technique pour {nom_de_la_catégorie} 3M G5. 3M G5 12 pages. Drive-thru systems
Également pour 3M G5 : Manuel de référence rapide (2 pages), Bulletin technique (6 pages), Bulletin technique (2 pages), Manuel (10 pages), Manuel de démarrage rapide (3 pages), Manuel (8 pages)

3M Graphics Warranties

3M™ Drive-Thru Systems

Install Vehicle Detector Board and Any External Antennas

Install Vehicle Detector Boards

The G5 Basestation can accommodate up to TWO vehicle detector boards and these MUST be connected to the

Order Point induction loops. Follow the procedure below to install them into the G5 basestation.

• Align the bottom of the vehicle detector board with the installation slot.

• Slide the top edge of the board between the back of the basestation and the two raised tabs.

• Install and gently tighten the screw.

• Carefully install the three wires between the vehicle detector board and the basestation board. The left-to-right pin

order is the same on both boards: the left pin on one corresponds to the left pin on the other.

• Configure the dip switches, if required, according to the table on the circuit board and your needs.

Dip Switch Settings

Technical Bulletin #161 Release B