Bose SoundTouch SA-4 Manuel - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Bose SoundTouch SA-4. Bose SoundTouch SA-4 34 pages. Amplifier
Également pour Bose SoundTouch SA-4 : Manuel du propriétaire (42 pages), Manuel du propriétaire (36 pages)
Imprimer la page
- 1. About Your Soundtouch™ Sa-4 Amplifier
- 2. Adding the System to Your Wi-Fi
- 3. Installing the Soundtouch™ Sa-4 Amplifier
- 4. Installing the Soundtouch™ Wireless Adapter
- 5. Connecting Speakers to the Sa-4 Amplifier
- 6. Alternate Setup Method
- 7. Troubleshooting
- 8. Appendix A: Sa-4 Amplifier Connector Panel
Setting up the System
Connecting speakers to the SA-4 amplifier
CAUTIONS:
• Use only unpowered speakers. DO NOT connect any make or model of
powered speakers. Doing so may cause damage to the equipment.
• The SoundTouch
Speaker cables consist of two insulated wires. Often, one wire is marked (striped,
colored, or ribbed), indicating it should be connected to the positive (+) terminal.
The plain wire should be connected to the negative (–) terminal. For recommended
wire sizes and lengths, see "Speaker cable recommendations" on page 27.
1.
Disconnect the SA-4 amplifier from AC (mains) power.
2.
Remove the terminal block connector from the SPEAKER OUTPUTS
connector on the rear panel of the SA-4 amplifier.
3.
Use a small, flat-head screwdriver to connect the left speaker cable to the
L positive (+) and minus (–) terminals of the 4-pin terminal block connector,
and the right speaker cable to the R positive (+) and minus (–) terminals.
Bose 251
shown for illustration only.
4.
Plug the terminal block connector into the SPEAKER OUTPUTS connector.
14 - English
SA-4 amplifier requires a 6-ohm minimum load.
™
Environmental Speakers
®