Bose Aviation Headset X Manuel du propriétaire - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Bose Aviation Headset X. Bose Aviation Headset X 36 pages. Owner's guide
Également pour Bose Aviation Headset X : Manuel du propriétaire (36 pages), Manuel d'installation rapide (1 pages), Manuel du propriétaire (16 pages), Manuel du propriétaire (36 pages)

Figure 6

Pulling the cable assembly

straight out from the earcup

Before you remove or attach the microphone, however, be sure to

note the important markings for left (L) and right (R) above each

earcup. These markings indicate which ear each earcup is intended

to fit over.

Removing an attached boom microphone cable

1. Use a Phillips or straight blade screwdriver to loosen the two

screws at the base of the boom microphone cable assembly.

2. Pull the cable assembly straight out from the earcup to which it

is attached (Figure 6).

CAUTION: Do not twist the boom microphone cable while disconnecting it.

Twisting can damage the connector pins.

Connector

Access

pins

cover

Cable

assembly

Before you attach the boom microphone, make sure that the cable

connector and its earcup connector are clean and free of debris.

1. Use a Phillips or straight blade screwdriver to loosen the two

screws on the access cover near the bottom of the earcup where

you want to attach the boom microphone.

2. Remove the cover to reveal the connector pins on the earcup.

3. Carefully line up the connector to the small connector pins on

the panel (Figure 7 on page 12).

CAUTION: An improperly aligned connector will not make the connections

necessary for proper operation, and may cause damage.

ETTING

OUR

EADSET

Connector

pins

EADY FOR

L for left