Bose Aviation Headset X Owner's Manual - Page 11
Browse online or download pdf Owner's Manual for Headsets Bose Aviation Headset X. Bose Aviation Headset X 36 pages. Owner's guide
Also for Bose Aviation Headset X: Owner's Manual (36 pages), Quick Setup Manual (1 pages), Owner's Manual (16 pages), Owner's Manual (36 pages)
Print Page
Figure 6
Pulling the cable assembly
straight out from the earcup
Before you remove or attach the microphone, however, be sure to
note the important markings for left (L) and right (R) above each
earcup. These markings indicate which ear each earcup is intended
to fit over.
Removing an attached boom microphone cable
1. Use a Phillips or straight blade screwdriver to loosen the two
screws at the base of the boom microphone cable assembly.
2. Pull the cable assembly straight out from the earcup to which it
is attached (Figure 6).
CAUTION: Do not twist the boom microphone cable while disconnecting it.
Twisting can damage the connector pins.
Connector
Access
pins
cover
Cable
assembly
Attaching the boom microphone cable
Before you attach the boom microphone, make sure that the cable
connector and its earcup connector are clean and free of debris.
1. Use a Phillips or straight blade screwdriver to loosen the two
screws on the access cover near the bottom of the earcup where
you want to attach the boom microphone.
2. Remove the cover to reveal the connector pins on the earcup.
3. Carefully line up the connector to the small connector pins on
the panel (Figure 7 on page 12).
CAUTION: An improperly aligned connector will not make the connections
necessary for proper operation, and may cause damage.
G
Y
H
ETTING
OUR
EADSET
Connector
pins
R
U
EADY FOR
SE
L for left
11