3M PELTOR WS LiteCom Pro III Manuel d'instructions de montage - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} 3M PELTOR WS LiteCom Pro III. 3M PELTOR WS LiteCom Pro III 6 pages.
Également pour 3M PELTOR WS LiteCom Pro III : Manuel (20 pages)

3M PELTOR WS LiteCom Pro III Manuel d'instructions de montage

Specifications

Model
Headband
Helmet attachment
Neckband
Built-in Two-way Radio
Frequency range
Operation mode
Channels
Channel separation
Modulation
Microphone type
Receiver sensibility
Selective squelch
Output power
Range
Operating temperature
Power
Li-Ion battery
Charging time
Capacity
Operating time
*can be increased up to 17 hours with the power save
feature
Storage
Recommended
storage condition
Recommended
max. shelf life
Use limitation: Never modify or alter this product
Weight (with ACK081)
490g
512g
475g
403 – 470 MHz
Simplex
70 programmable channels
12,5 kHz and 25 kHz
Analog: 2,5 kHz (FM)
and 5 kHz (FM)
Digital: 2,5 kHz (4-level FSK)
Dynamic (MT73)
Typical -120 dBm
Programmable (supports
CTCSS and DCS)
200 / 20 / 10 mW ER
Outdoors up to 2 km
depending on conditions
-20°C to +50°C
ACK081, included in delivery
approx. 4 hours
3,7 V, 1800 mA, 6,7 Wh
up to 11 hours* (90 stby /
5 tx / 5 rx)
-20º C - +40º C,
<90% humidity
Headset: 3 years
Battery: 1 year

Fitting Instructions

Inspect the hearing protector before each use. If damaged,
select an undamaged hearing protector or avoid the noisy
environment.
When additional personal protective equipment is necessary
(e.g. safety glasses, respirators, etc.), select flexible, low
profile temples or straps to minimize interference with the
earmuff cushion. Remove all other unnecessary articles (e.g.
hair, hats, jewelry, headphones, hygiene covers, etc.) that
could interfere with the seal of the earmuff cushion and
reduce the protection of the earmuff.
Headband Headset
To fit the hearing protector:
1. Slide out the cups and tilt the top of the cup out, as the
cable must be on the outside of the headband (Fig 1).
2. Pull the cups apart and place the earmuffs over the ears
so that the cushions form a snug seal around the ears.
3. Adjust the height of the cups by sliding them up or down
while holding the headband in place (Fig 2).
4. The headband should be positioned across the top of
your head (Fig 3).
Neckband Headset
To fit the hearing protector:
1. Place the cups in position over the ears (Fig 1).
2. Keep the cups in position, place the head strap on top of
your head and lock it tight in position (Fig 2).
3. The head strap should be positioned across the top of
your head and should support the weight of the headset
(Fig 3).
Caution: The neckband earmuffs must be worn with
the head strap correctly attached to keep them firmly
in position to maintain an effective acoustic seal. The
protection level provided by neckband earmuffs may be
reduced if the head straps are not worn correctly.
1
2
3