3M PELTOR WS LiteCom Pro III 피팅 지침 매뉴얼 - 페이지 2

{카테고리_이름} 3M PELTOR WS LiteCom Pro III에 대한 피팅 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M PELTOR WS LiteCom Pro III 6 페이지.
3M PELTOR WS LiteCom Pro III에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지)

페이지 인쇄

Specifications

Model

Headband

Helmet attachment

Neckband

Built-in Two-way Radio

Frequency range

Operation mode

Channels

Channel separation

Modulation

Microphone type

Receiver sensibility

Selective squelch

Output power

Range

Operating temperature

Power

Li-Ion battery

Charging time

Capacity

Operating time

*can be increased up to 17 hours with the power save

feature

Storage

Recommended

storage condition

Recommended

max. shelf life

Use limitation: Never modify or alter this product

Weight (with ACK081)

490g

512g

475g

403 – 470 MHz

Simplex

70 programmable channels

12,5 kHz and 25 kHz

Analog: 2,5 kHz (FM)

and 5 kHz (FM)

Digital: 2,5 kHz (4-level FSK)

Dynamic (MT73)

Typical -120 dBm

Programmable (supports

CTCSS and DCS)

200 / 20 / 10 mW ER

Outdoors up to 2 km

depending on conditions

-20°C to +50°C

ACK081, included in delivery

approx. 4 hours

3,7 V, 1800 mA, 6,7 Wh

up to 11 hours* (90 stby /

5 tx / 5 rx)

-20º C - +40º C,

<90% humidity

Headset: 3 years

Battery: 1 year

Fitting Instructions

Inspect the hearing protector before each use. If damaged,

select an undamaged hearing protector or avoid the noisy

environment.

When additional personal protective equipment is necessary

(e.g. safety glasses, respirators, etc.), select flexible, low

profile temples or straps to minimize interference with the

earmuff cushion. Remove all other unnecessary articles (e.g.

hair, hats, jewelry, headphones, hygiene covers, etc.) that

could interfere with the seal of the earmuff cushion and

reduce the protection of the earmuff.

Headband Headset

To fit the hearing protector:

1. Slide out the cups and tilt the top of the cup out, as the

cable must be on the outside of the headband (Fig 1).

2. Pull the cups apart and place the earmuffs over the ears

so that the cushions form a snug seal around the ears.

3. Adjust the height of the cups by sliding them up or down

while holding the headband in place (Fig 2).

4. The headband should be positioned across the top of

your head (Fig 3).

Neckband Headset

To fit the hearing protector:

1. Place the cups in position over the ears (Fig 1).

2. Keep the cups in position, place the head strap on top of

your head and lock it tight in position (Fig 2).

3. The head strap should be positioned across the top of

your head and should support the weight of the headset

(Fig 3).

Caution: The neckband earmuffs must be worn with

the head strap correctly attached to keep them firmly

in position to maintain an effective acoustic seal. The

protection level provided by neckband earmuffs may be

reduced if the head straps are not worn correctly.