Daintree GE current WGA100 Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Daintree GE current WGA100. Daintree GE current WGA100 9 pages. General purpose adapter

Imprimer la page

Daintree

Purpose Adapter

(WGA100)

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Save these instructions for future use.

WARNING

Risk of electrical shock. Disconnect power before servicing or

installing product.

Install in accordance with National Electric Code and local codes.

The WGA100 Wireless General Purpose Adapter forms part of

the Daintree Networked wireless controls solution for commercial

and industrial buildings. It transmits and receives messages over

the wireless ZigBee

network to monitor and control a variety of

devices used in building management.

The WGA100 is an AC powered device that provides On/Off

switching and 0-10V analog control as well as reporting and

monitoring capability of binary and 0-10V analog signal inputs

for non-lighting applications. It provides power for low voltage

sensors, switches, and analog control signals and provides the

wireless adaptation that enables them to communicate with the

rest of the wireless control solution. The control signals to and

from these devices pass between the WGA100 and the Wireless

Area Controller (WAC) in the Daintree Networked platform.

Installation Process

1. Disconnect power before installation. Turn off all power

to affected light fixtures by turning off circuit breakers.

Confirm that power is off at all light fixtures before

continuing installation.

2. Set the WGA100 DIP switches to support the device(s) it will

monitor or control. See DIP Switch Settings (pages 2).

3. IMPORTANT: Put the WGA100's "Plan" label (with 4-5 digits

of the IEEE address) on the floor plan to indicate its location.

4. Mount the WGA100 to a junction box or enclosure

approved for the application. See Mounting (page 7).

5. Connect low voltage wiring from the WGA100 to the

device(s) as appropriate for your application. See Wiring

(pages 3-6).

General

Risk of injury. Wear safety glasses and gloves during installation and

servicing.

6. Connect line voltage wiring from the supply circuit to

the WGA100 as described in Wiring (pages 3-6).

7. Check load circuits then turn on the circuit breakers

to power up the WGA100. Device(s) connected to the

WGA100 binary outputs [line voltage Switched Load (BO1)

and 24VDC LSD (B02)] are OFF when power is initially

applied (and when power is restored after a power failure).

8. Ensure the WGA100 green Power

9. Press and hold the blue RESET button on the WGA100 for

3 seconds to reset the unit. Release the button when the green

Joined LED and the red Error LEDs begin flashing.

10. Perform the installation test appropriate for your application.

See Installation Tests (page 8).

Error/Test — On when the Wireless Adapter is in an error state.

Flashes to indicate unit Reset and during Installation Test Mode (red).

Joined — On when the Wireless Adapter has joined a ZigBee

Flashes to indicate Reset and during sensor Installation Test Mode (green).

Power — On when power is applied to the Wireless Adapter (green).

Installation Guide

WGA100 | DT110

CAUTION

LED is On.

LED Indicators

Error

Joined

Power

Reset

LED

Button

network.