Absolute Measurement CLT Manuel d'instruction - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Absolute Measurement CLT. Absolute Measurement CLT 9 pages.

Transducer Instruction Manual

Range:

Ultra

Type:

CLT

Revision:

V1.0

2.8

Sensing Roller Installation

The transducer has a choice of adaptors with bores of 17, 20, 25, 30 and 35mm diameter, to accept a

shaft to which a tension sensing roller or guide pulley can be mounted as shown below. Two set screws

at 90 degrees are used to hold the shaft in place. The tension sensing roller or guide pulley should be

dynamically balanced when the roller speed exceeds 300 RPM as excessive vibration can damage the

transducer. Any out of balance force should not exceed 10% of the maximum working force (MWF) of the

transducer.

The recommended maximum roller length is 450mm to avoid an excessive bending moment being

applied to the transducer and roller deflection.

_____________________________________________________________________________________________________________________

Absolute Measurement Ltd. (T/A CMC Controls)

t: (0) 1732 763278

| e:

Unit 19

| Silver Birches Business Park | Aston Road | Bromsgrove | B60 3EU

| w: absolutemeasurement.co.uk