DSC Misterhouse PC5401 Instructions d'installation

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} DSC Misterhouse PC5401. DSC Misterhouse PC5401 2 pages. Data interface module

Imprimer la page

The PC5401 Data Interface Module can be used to quickly and easily communicate

with PowerSeries™ panels through a standard RS-232 serial connection. (See the

PC5401 Developer's Guide for more information on communicating with the PC5401

module) at www.dsc.com/support/installation manuals.

Specifications

Module Current Draw: 35 mA

Terminal Connections

KEYBUS - The 4-wire KEYBUS connection is used by the panel to communicate

with the module. Connect the RED, BLK, YEL and GRN terminals to the KEYBUS

terminals on a PowerSeries™ panel.

DB9 – Requires a "straight-through" RS-232 cable. Only the RX, TX and GND

connections are used. Note: cable should not exceed 50 ft at 9600 BAUD (consult

RS-232 Signaling Standard for more information)

To Connect Module to a Control Panel

This module can be installed in any of the following enclosures: PC4003C,

PC5003C, HS-CAB1000, HS-CAB3000, HS-CAB4000.

1. Connect module to the KEYBUS (with the panel powered down).

2. Select desired BAUD using JP1-3 (default is 9600 BAUD, see Table 1).

2. Connect an RS-232 cable to the application.

3. Power up the system.

Figure 1

To Panel

Notes:

• The PC5401 is designed to be installed by SERVICE PERSONS only.

• These instructions shall be used in conjunction with the applicable

Installation Instructions of the used PowerSeries™ alarm controller.

Installation Instructions

JP1

JP2

JP3

RED

BLK

YEL GRN

RS-232

To Application

PC54O1

Data Interface Module

Version 1.O