3MillID S-Gang Keypad Reader Manuel - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} 3MillID S-Gang Keypad Reader. 3MillID S-Gang Keypad Reader 12 pages. Access control reader
Imprimer la page
3.
installation guide
1
Remove module securement screw. Lever bottom edge of reader module away
from the backplate, and lift up.
2
Fix reader BACKPLATE to a plain surface finish, using suitable screw fixings
having a diameter no greater than 4mm (0.15 inch).
If printed full scale, you may use the drawing below as a fixing template.
i
MEASURE and CHECK DIMENSIONS before use.
NOTE:
Mounting this reader on (or near) metal may impair the read range of the unit.
Fasten the reader module, ensuring the top-edge fixings engage correctly with the
recesses at the top of the backplate. Swing the bottom edge of the module down
3
and forward until you feel the unit 'snap' shut.
Secure the module to the backplate using the M3x10mm screw supplied.
Following installation, it is recommended the access control system and control
i
units are subjected to a maintenance and operational test procedure.
TEST COMPLETE SYSTEM AT LEAST ONCE A YEAR
© 3millID
100-02640-A
53.0mm
2.1 inches
Fixing holes - 4mm
maximum diameter.
centreline
BACKPLATE
60.3mm (UK/EU)
2.4 inches
If required, you may opt to use a security screw to the sizes shown here.
1
2
i
Once
the
backplate
secured,
make
wire
connections to the reader, in
accordance with the screw
terminal connections shown
on Page 3 of this document
and
your
control
panel
requirements. Ensure the
cable does not impair or
prevent the reader module
being secured.
3millID 9249 S. Broadway Building #200 Suite 826 Highlands Ranch CO 80129
www.3millid.com
3M
S-Gang
Keypad
MANUAL
3
is
+1 303 475 4972
4