3MillID S-Gang Keypad Reader 매뉴얼 - 페이지 4

{카테고리_이름} 3MillID S-Gang Keypad Reader에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3MillID S-Gang Keypad Reader 12 페이지. Access control reader

페이지 인쇄

installation guide

Remove module securement screw. Lever bottom edge of reader module away

from the backplate, and lift up.

Fix reader BACKPLATE to a plain surface finish, using suitable screw fixings

having a diameter no greater than 4mm (0.15 inch).

If printed full scale, you may use the drawing below as a fixing template.

MEASURE and CHECK DIMENSIONS before use.

NOTE:

Mounting this reader on (or near) metal may impair the read range of the unit.

Fasten the reader module, ensuring the top-edge fixings engage correctly with the

recesses at the top of the backplate. Swing the bottom edge of the module down

and forward until you feel the unit 'snap' shut.

Secure the module to the backplate using the M3x10mm screw supplied.

Following installation, it is recommended the access control system and control

units are subjected to a maintenance and operational test procedure.

TEST COMPLETE SYSTEM AT LEAST ONCE A YEAR

100-02640-A

53.0mm

2.1 inches

Fixing holes - 4mm

maximum diameter.

centreline

BACKPLATE

60.3mm (UK/EU)

2.4 inches

If required, you may opt to use a security screw to the sizes shown here.

Once

the

backplate

secured,

make

wire

connections to the reader, in

accordance with the screw

terminal connections shown

on Page 3 of this document

and

your

control

panel

requirements. Ensure the

cable does not impair or

prevent the reader module

being secured.

3millID 9249 S. Broadway Building #200 Suite 826 Highlands Ranch CO 80129

www.3millid.com

S-Gang

Keypad

MANUAL

[email protected]

+1 303 475 4972