DSM SUM-40 Manuel d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} DSM SUM-40. DSM SUM-40 6 pages.

Motor speed (deg/sec)

Connections and installation

The motor mounts via four 3.4mm clearance holes arranged in a 31 mm pattern. These clearance

holes can be used with either M3 or #4 screws. The output is a 4 mm diameter D-profile shaft

extending approximately 11.2 mm out of the face of the motor. DSM recommends the use of

flexible shaft couplers when installing the motor to avoid placing off-axis loads onto the motor

output shaft.

The motor has an internal bearing capable of supporting up to 20 N pulling away from the motor

or 10 N pushing into the motor. The bearing can also support a maximum of 20 N of radial load

applied to the tip of the output shaft. Motor performance may be degraded slightly when fully

loaded in this way. DSM recommends isolating the SUM-40 motor with external bearings and

couplers designed for correcting shaft misalignments.

The SUM-40 motor has two connections on it; one multi-function connector, and one USB type

C connector. The multi-function connector has one digital input, one digital output, RS-232

connections, a 12 V input, and a Ground connection. The USB type C connector is for

communication only. The SUM-40 must be powered by the multi-function connector, but

communication is possible either by the RS-232 pins on the multi-function connector or the USB

type C connector.

Max continuous runtime

100

400

800

1200

R. 171011

(minutes)

114 Southeast Parkway Ct.

Ste 160

Franklin, TN 37064

Tel: 615/595-6665

Fax: 615/595-6610