ATSI RMBC64-24D HAWK Manuel de l'opérateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} ATSI RMBC64-24D HAWK. ATSI RMBC64-24D HAWK 13 pages. Hawk 3 stage electronic battery charger
Imprimer la pageRMBC64-24D ELECTRONIC BATTERY CHARGER
Introduction
Handling Requirements
Maximum stacking height.
Minimum clearance for ventilation.
Power requirements.
Weight.
Dimensions.
Installation.
Remove front cover by un-clipping side clips.
Check that the power switch is in the OFF position.
Lower back flap by twisting anti-clockwise "Zuse" fasteners to expose
mains input socket and ventilation fans.
Ensure both charger and mains is switched OFF before connecting power
lead to charger socket. Ensure both charger socket and power lead are
clean and dry before connecting.
Connect power lead (RMBCPL) by pushing plug into socket via locating
pins.
Connect charger lead (RMBCL24) plug to the 41 pin Amphenol socket
located on the front of the charger panel and charger lead socket to the
HAWK battery charge input plug.
The charger is ready for use.
2 x Units on top of each other.
25mm each side and 50mm at rear.
110 >240 volts AC @ 6.5 Amps.
16.5Kgs.
200 x 380 x 570mm (H x W x D)