ATTIAS USA-60 Installation et fonctionnement - Page 7

Parcourez en ligne ou téléchargez le pdf Installation et fonctionnement pour {nom_de_la_catégorie} ATTIAS USA-60. ATTIAS USA-60 11 pages. Commercial dough mixers

Imprimer la page
A Drain Plug is located on the bottom of the planetary. Should draining become
necessary, remove the Drip Cup- Splash Guard and place a suitable catch pan under the
draining plug. Remove the drain plug, allow oil to completely drain, and replace the
drain plug. Remove the fill plug and pour in six fluid ounces of the recommended
planetary lubricant. Replace the Fill Plug and the Drip Cup-Splash Guard. Contact
ATTIAS OVEN CORP. for the recommended planetary lubricant.
Planetary Seal
Occasionally, the planetary seal may become dry and begin to squeak. To correct this,
work a little lubrication under the lip of the seal.
Transmission
The transmission oil should be even with the line on the Oil Level Gauge when the
motor is NOT running. If the oil falls below this line, DISCONNECT ELECTRICAL POWER
SUPPLY and remove the Top Cover, which is secured by two screws. Remove the
Transmission Fill Plug and add a small amount of the recommended transmission oil
until it returns to the proper level.
DO NOT overfill the transmission as leakage may result. Contact you ATTIAS OVEN
CORP. for the recommended transmission oil.
Bowl Lift
The slideways and lift screw should be lubricated approximately twice a year. To reach
these areas, fully lower the bowl support and remove the apron, which is secured by
four thumb screws. Wipe a thin coat of lubricate on the bowl clamp area of the bowl
supports, each slide way, and the lift screw. Replace the apron.
Note: on units with a manual bowl lift, the handwheel gearing should be lubricated
periodically. To do this, DISCONNECT ELECTRICAL POWER SUPPLY and remove the top
cover. Wipe a coat of Lubricate on the gear teeth and replace the top cover.
ADJUSTMENTS

AGITATOR CLEARANCE

The agitator clearance should be checked with each bowl change. The agitator must
not touch the bowl and the maximum clearance between the bottom of the bowl and
the Flat Beater is 1/8"; the maximum clearance between the bottom of the bowl and
the Dough Arm is 5/16".
Install a Bowl and Agitator. If the Bowl and Beater come into contact before the Bowl
Support reaches its stop, adjust the Stop Screw upwards following the procedure below.