ATTIAS USA-60 Installation et fonctionnement - Page 8

Parcourez en ligne ou téléchargez le pdf Installation et fonctionnement pour {nom_de_la_catégorie} ATTIAS USA-60. ATTIAS USA-60 11 pages. Commercial dough mixers

Imprimer la page
TO MEASURE THE CLEARANCE
Pour enough flour in the bowl to cover the bottom of the bowl where the beater travels.
With the bowl fully raised, briefly run the mixer in speed 1.
Turn off the mixer, DISCONNECT ELECTRICAL POWER SUPPLY, and measure the depth
of flour where the beater has traced a path. This measurement should be taken at
several points around the bowl to assure accuracy.
TO ADJUST THE BOWL/AGITATOR CLEARANCE
• Remove the Apron.
• Loosen the bottom Locking Nut and turn the Stop Screw counterclockwise to
increase the clearance or clockwise to decrease clearance.
• Tighten the Locking Nut while holding the Stop Screw.
CAUTION: Make sure the switch button on the bowl height sensing switch is
never below the bottom of the actuator.
• When the Bowl Support is fully raised, the Switch Button on the Bowl Height
Sensing Switch should be 1/8" above the bottom of the Nylon Actuator to move
it up or down.
• After the adjustments are made, replace the Apron.
• Reconnect the electrical power supply.
• Carefully operate the bowl lift several times to check the adjustment
BOWL CLAMPS
The height of the bowl clamp is controlled by a spring washer and lock nut, which are
located on the bottom of the bowl support. Turning the lock nut clockwise will loosen
the clamp, counterclockwise will tighten it. If repeated adjustments are necessary, or
additional service is indicated. Contact ATTIAS OVEN CORP. for more information.