DT Research DT395CR Manuel d'utilisation de base - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation de base pour {nom_de_la_catégorie} DT Research DT395CR. DT Research DT395CR 10 pages. Mobile pos tablet
Également pour DT Research DT395CR : Manuel d'utilisation de base (4 pages), Manuel d'utilisation de base (4 pages)
Imprimer la page
Input/ Output Ports
A
Barcode Scanner (optional)
B
Headphone Jack
C
USB Port
D
DC Power Input
E
Camera (optional)
F
LAN and HDMI-in (optional)
G
LAN and 6-pin lockable connector for EIA/RS-232/422/485 (adapter cable required) (optional)
Button Functions
BUTTON
ACTION
1
Programmable button without the scanner module
As scanner trigger when equipped with the scanner module
2
Power on.
Push/release typically enters Standby mode, or Push/release exits Standby mode or
restarts (software dependent)
Push and hold (over 4 seconds) invokes hardware shutdown
3
Brightness control button, 5 levels
4
Up/ down button
To adjust the speaker volume
5
Display mode switch.
To switch to display the video signal from HDMI port
Battery and Power Management
The DT395CR is equipped with an internal Li-Ion battery pack and an optional battery pack that clips
(hot-pluggable) onto the back of the tablet. The period between battery recharges can be significantly
lengthened by putting the tablet into Standby mode through the Power Button (see Buttons Function Table)
whenever the tablet is not in use. Depending on the operating software, the DT395CR may also be configured
to enter various power-saving modes via the Power Button or through timed entry.
3
ENGLISH