DT Research DT395CR 기본 작동 매뉴얼 - 페이지 3
{카테고리_이름} DT Research DT395CR에 대한 기본 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DT Research DT395CR 10 페이지. Mobile pos tablet
DT Research DT395CR에 대해서도 마찬가지입니다: 기본 작동 매뉴얼 (4 페이지), 기본 작동 매뉴얼 (4 페이지)
페이지 인쇄
Input/ Output Ports
A
Barcode Scanner (optional)
B
Headphone Jack
C
USB Port
D
DC Power Input
E
Camera (optional)
F
LAN and HDMI-in (optional)
G
LAN and 6-pin lockable connector for EIA/RS-232/422/485 (adapter cable required) (optional)
Button Functions
BUTTON
ACTION
1
Programmable button without the scanner module
As scanner trigger when equipped with the scanner module
2
Power on.
Push/release typically enters Standby mode, or Push/release exits Standby mode or
restarts (software dependent)
Push and hold (over 4 seconds) invokes hardware shutdown
3
Brightness control button, 5 levels
4
Up/ down button
To adjust the speaker volume
5
Display mode switch.
To switch to display the video signal from HDMI port
Battery and Power Management
The DT395CR is equipped with an internal Li-Ion battery pack and an optional battery pack that clips
(hot-pluggable) onto the back of the tablet. The period between battery recharges can be significantly
lengthened by putting the tablet into Standby mode through the Power Button (see Buttons Function Table)
whenever the tablet is not in use. Depending on the operating software, the DT395CR may also be configured
to enter various power-saving modes via the Power Button or through timed entry.
3
ENGLISH