DTAR Wave-Length Manuel d'instructions d'installation - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} DTAR Wave-Length. DTAR Wave-Length 16 pages. Under saddle transducer
Imprimer la page
FIGURE 2
7. Using the custom preamp insertion tool, test fit and adjust
the nut and lock washer on the end pin jack so that the
larger diameter of the jack body is completely within the
hole.
8. When the jack depth has been properly set up, slide it into
the endpin hole and finger tighten the small flat washer and
nut. Place a phillips screwdriver (or allen wrench, finishing
nail, etc) through the cross-drilled hole to keep the jack
from turning and tighten the retaining nut securely. Do not
attempt to keep the jack from rotating by holding the
chassis of the preamp. This will damage the preamp and
void any warranty.
9. Install the strap button securely. A small length of the
threaded portion of the jack should protrude slightly
beyond the strap button or minimally be flush with the outer
surface. The will insure that the instrument patch cord can
be fully plugged into the jack.
www.dtar.com
9
|