DTAR Wave-Length 설치 지침 매뉴얼 - 페이지 9

{카테고리_이름} DTAR Wave-Length에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DTAR Wave-Length 16 페이지. Under saddle transducer

FIGURE 2

7. Using the custom preamp insertion tool, test ﬁt and adjust

the nut and lock washer on the end pin jack so that the

larger diameter of the jack body is completely within the

hole.

8. When the jack depth has been properly set up, slide it into

the endpin hole and ﬁnger tighten the small ﬂat washer and

nut. Place a phillips screwdriver (or allen wrench, ﬁnishing

nail, etc) through the cross-drilled hole to keep the jack

from turning and tighten the retaining nut securely. Do not

attempt to keep the jack from rotating by holding the

chassis of the preamp. This will damage the preamp and

void any warranty.

9. Install the strap button securely. A small length of the

threaded portion of the jack should protrude slightly

beyond the strap button or minimally be ﬂush with the outer

surface. The will insure that the instrument patch cord can

be fully plugged into the jack.