DTAR Wave-Length 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} DTAR Wave-Length에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DTAR Wave-Length 16 페이지. Under saddle transducer

Tools required

1. Electric Drill with ½" chuck.

2. 7/64" and 1/8" drill bits for drilling pickup hole.

3. An acceptable cutting bit to enlarge the endpin hole, some

recommendations are:

Step Drill

2 step endpin reamer (Stewart MacDonald #4323)

15/32" drill bit with ﬂutes ground for 0-degree rake

4. Small screwdriver with 1/8' wide blade or slightly narrower.

5. Small Crescent wrench for tightening nut on endpin jack.

6. Small Phillips head screwdriver, allen wrench or ﬁnishing

nail to prevent jack from turning as you tighten the nut.

7. Special home-made preamp insertion tool:

A modiﬁed ¼" plug attached to a 2 ft. length of

3/16" dia. wooden dowel or stiff copper wire (solid

conductor). This will help guide the endpin jack through

the hole in the end block from the outside.