DTAR Wave-Length Manuale di istruzioni per l'installazione - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Trasduttore DTAR Wave-Length. DTAR Wave-Length 16. Under saddle transducer
Stampa la pagina
Tools required
1. Electric Drill with ½" chuck.
2. 7/64" and 1/8" drill bits for drilling pickup hole.
3. An acceptable cutting bit to enlarge the endpin hole, some
recommendations are:
a.
Step Drill
b.
2 step endpin reamer (Stewart MacDonald #4323)
c.
15/32" drill bit with flutes ground for 0-degree rake
4. Small screwdriver with 1/8' wide blade or slightly narrower.
5. Small Crescent wrench for tightening nut on endpin jack.
6. Small Phillips head screwdriver, allen wrench or finishing
nail to prevent jack from turning as you tighten the nut.
7. Special home-made preamp insertion tool:
a.
A modified ¼" plug attached to a 2 ft. length of
3/16" dia. wooden dowel or stiff copper wire (solid
conductor). This will help guide the endpin jack through
the hole in the end block from the outside.
www.dtar.com
7
|