DTG M2 Manuel de remplacement - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de remplacement pour {nom_de_la_catégorie} DTG M2. DTG M2 8 pages. Printhead cable replacement
Imprimer la pageM2 (PRINTHEAD CABLE REPLACEMENT)
(Always POWER DOWN printer and UNPLUG before doing any repair work)
11. In some cases your NEW FFC cables will not be "PRE-FOLDED" to fit yout machine. If your
cables are "PRE-FOLDED" move on to step 12. If they
steps below.
Mark your
cables on the print head end.
EXISTING
CR BOARD and mark it the with corresponding marks on that end.
Then tape the
EXISTING
Remove the cables from the CR BOARD and use them as a template to fold your new cables.
Fig 1-J
Fig 1-L
12.Gently unplug your existing cables from the CR BOARD. Plug your new cables into
the CR BOARD. Be sure the teeth of the cables are facing correct way, start with slot 1.
(Indicated below 1-L)
Revision Date / Version: 2/13/2014 - 7
cables together
(in this example I am using paper clips to hold the cables together)
UPPER SLOT CABLE
(SLOT 1 on printhead)
LOWER SLOT CABLE
(SLOT 2 on printhead)
The fold doesn't have to be an EXACT match, the
main goal is too insure that the cables are plugged in
correctly.
For example: The "1U" (SLOT 1 UPPER CABLE) is
plugged into the corresponding slot on the CR BOARD.
If the cables aren't facing the right direction or the slot
on the head or CR BOARD are switched, the printer
will error upon start up.
This is the correct position
for the UPPER SLOT CABLE
on the CR BOARD
(SLOT 1 on printhead)
(J205 to HEAD CN2)
This is the correct position
for the LOWER SLOT CABLE
on the CR BOARD
(SLOT 2 on printhead)
(J204 to HEAD CN1)
ARE NOT
"PRE-FOLDED" follow the
,then follow each cable to the
(Indicated below 1-J)
(Indicated below 1-K)
Fig 1-K