dtm MICRO2 868 Manuel d'installation et d'assemblage - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'assemblage pour {nom_de_la_catégorie} dtm MICRO2 868. dtm MICRO2 868 12 pages. 2-channel radio receiver

Imprimer la page

2.3. Easy remote adding function

Easy remote adding function allows to register remote without physical access to receiver buttons. It is neccessary to be in

receiver radio range and to have previously added remote.

For easy adding press, in receiver radio range, for 15 seconds button of already added remote. Then, in time no longer than 3

seconds, press and hold for 15 seconds button of remote you want to add.

REMOTE IN RECEIVER

RANGE

Fig. 5. Easy remote adding.

Easy remote adding function is not available when:

channel is configurated in momentary mode

easy remote adding function is locked

if used remotes are two of a different frequency

service lock is on

Failure in easy remote adding may be caused by:

low battery of remote

radio interference during procedure

receiver memory full

2.4. Easy remote adding function locking / unlocking

To secure the device against unwanted remote adding (especially important in access protected zones) easy remote adding

function must be locked. To lock/unlock function press and hold C1 and C2 buttons, then release one C1 or C2 button. After 5

secondsC1 andC2 LEDs will light on alternately every 5 seconds.

Releasing secondC1 orC2 button when:

C1 LED lights on - easy remote adding function locked,

C2 LED light on - easy remote addin function unlocked.

Releasing second button in time no more than 5 seconds from releasing first button will cause leaving the procedure

without saving changes.

DTM System

spółka z ograniczoną odpowiedzialnością spółka komandytowa

PRESS BUTTON

OF „OLD" REMOTE

FOR 15 SECONDS

PRESS AND HOLD C1 AND C2

RELEASE BUTTON WHEN

C1 ON

- EASY ADDING LOCKED

AFTER MAX. 3 SECONDS

RELEASE C2

RELEASE BUTTON WHEN

C2 ON

- EASY ADDING UNLOCKED

Fig.6. Locking/unlocking easy remote adding.

REMOTE IN RECEIVER

RANGE

PRESS BUTTON

OF „NEW" REMOTE

FOR 15 SECONDS

AFTER 5 SECONDS

C1 AND C2 LEDs WILL

LIGHT UP ALTERNATELY