daltile 1020 TS Manuel d'utilisation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} daltile 1020 TS. daltile 1020 TS 16 pages. Tile

Imprimer la page

Cutting Straight Edges

DO NOT FORCE THE TOOL! It will do the job

better and safer at the rate for which it was

designed.

Loosen the Adjustable Cutting Guide

retaining knob.

Position the Adjustable Cutting Guide to

desired cutting length.

Tighten the retaining knob.

Place the tile against the Ruler/Stop

and Cutting Guide.

Turn the motor ON.

Verify proper coolant flow on both sides of

the blade.

Perform the cut.

Turn the motor OFF when work is

complete.

Single Step Cutting

(Use only original saw blades as advised by

the manufacturer)

Move saw head down until the saw is

approx. 3/8" below the saw table.

Secure saw head with the knob.

Place the material to be cut on the sawing

table and position against the fixed stop

and eventually the adjustable stop.

Hold the material with two hands while

making sure your hands are free from the

sawing blade.

Push the sawing table forward with control-

led feed so that the sawing blade is easily

cutting through the material.

Multiple Step Cutting

With this sawing process the sawing blade must

be adjusted to a desired cutting depth. The

material can be cut to the adjusted depth by

PAGE 14 DALTILE 1020TS OPERATING MANUAL V02/2004R1

OPERATING INSTRUCTIONS

moving the sawing table forward and bac-

kward. This process can be repeated until the

material has been totally cut through.

Place the material to be cut on the sawing

table and position against the fixed stop

and eventually the adjustable stop.

Position the saw head at the desired height

Hold the material with two hands while

making sure your hands are free from the

sawing blade.

Push the sawing table forward with control-

led feed so that the sawing blade is easily

cutting through the material and move the

sawing table backward in its initial posi-

tion. This process must be repeated until

the material has been totally cut through.

45˚ Miter Cutting:

NOTE: To cut 45º Miters, the 45º Miter Guide

should be used.

Remove the Adjustable Cutting Guide.

Place the 45º Miter Guide on the Saw

Table and tighten the retaining thumb

screw. Position the tile on the 45º Miter

Guide.