daltile 1020 TS Manuel d'utilisation - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} daltile 1020 TS. daltile 1020 TS 16 pages. Tile

Imprimer la page

General Maintenance

The cooling water should be replaced

and/or replenished regularly.

It is recommended to clean the water con-

tainer, pump, hoses and spray nozzle on a

regular basis. For example, place the

pump in a bucket of clean water after the

sawing job and run the machine for a

minute or so. This also guarantees

a longer lifetime of the pump.

When the machine is not used for a longer

period, the pump should not remain in the

muddy cooling water. Cleaning the pump

as described above and leaving it outside

the water container is recommended.

Regularly check the saw flanges for wea

ring out and replace if necessary.

V-Belt Inspection, Adjustment

and Replacement:

The DalTile 1020TS is designed with a power

transmission V-belt. In order to ensure the

DalTile 1020TS operates at peak efficiency, the

V-belt should be inspected monthly, and chan-

ged if the V-belt shows damage and/or excessi-

ve wear.

When a new belt is installed, it should be

inspected and re-tensioned after the first forty-

eight (48) hours of operation.

A. Ensure the ON/OFF Switch is in the OFF

position.

B. Unplug from the power source.

C. Remove the saw blade.

D. Remove the belt guard.

E. Inspect the V-belt for cracks, fraying,

separation and wear. Go to step G if

replacement is required.

F. Check the belt for proper tension. If the

tension T is correct (approx. 1 5/8") go to

step Q.

MAINTENANCE

G. Loosen the motor mounting bolts, if re-

tensioning only go to step M.

H. Loosen the motor adjustment strap.

I. Push the motor toward the front of the

Cutting Head to loosen the V-belt.

J. Remove the old V-belt.

K. Install the new V-belt.

L. Verify the V-belt is seated in the grooves

of both pulleys.

M. Tighten the motor adjustment strap to

remove slack.

N. Check V-belt tension (proper tension

1 5/8")

O. Repeat steps M and N until proper V-belt

tension is achieved.

P. Tighten the motor mounting bolts.

Q. Install the belt Guard.

DALTILE 1020TS OPERATING MANUAL V02/2004R1 PAGE 15