concept 2 DYNO Manuel d'instructions de montage - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} concept 2 DYNO. concept 2 DYNO 12 pages.

Attach the assembled Pull Side Leg and the Pull

Side Seat Brackets to the Monorail using two

3/8" by 2 5/8" bolts and two 3/8" nuts. This is

the trickiest step in the assembly because you

have to align six holes and get one bolt through

them all.

Hint: Position the seat brackets one at a time, as

shown in the photo at right and below left.

Use one of the long bolts provided as an

alignment tool. Insert it from the other side

to line up the holes in the Monorail and Leg,

while you insert and align the Bracket. Insert

the proper bolt from your side, removing the

aligning bolt from the back as you go.

12a. Attach the Pull Side Seat to the Pull Side Seat

Brackets using the four #10 x 1/2" Phillips head

screws and the four #10 lock washers. Tighten

these screws firmly.

11/01

11a. Install the first bolt through the lower holes in

the Monorail and Leg, and the lower hole of the

Pull Side Seat Bracket. Note that the seat

brackets go between the sides of the Monorail

and the Leg, which may be a snug fit.

11b. Install the second bolt by repeating the process.

Do not tighten yet.

12b. Now firmly tighten the two bolts from step 11b.