ページを印刷する
Attach the assembled Pull Side Leg and the Pull
Side Seat Brackets to the Monorail using two
3/8" by 2 5/8" bolts and two 3/8" nuts. This is
the trickiest step in the assembly because you
have to align six holes and get one bolt through
them all.
Hint: Position the seat brackets one at a time, as
shown in the photo at right and below left.
Use one of the long bolts provided as an
alignment tool. Insert it from the other side
to line up the holes in the Monorail and Leg,
while you insert and align the Bracket. Insert
the proper bolt from your side, removing the
aligning bolt from the back as you go.
12a. Attach the Pull Side Seat to the Pull Side Seat
Brackets using the four #10 x 1/2" Phillips head
screws and the four #10 lock washers. Tighten
these screws firmly.
11/01
11a. Install the first bolt through the lower holes in
the Monorail and Leg, and the lower hole of the
Pull Side Seat Bracket. Note that the seat
brackets go between the sides of the Monorail
and the Leg, which may be a snug fit.
11b. Install the second bolt by repeating the process.
Do not tighten yet.
12b. Now firmly tighten the two bolts from step 11b.
5