Anyload EC200 Manuel d'utilisation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Anyload EC200. Anyload EC200 16 pages.
Également pour Anyload EC200 : Manuel de l'utilisateur (8 pages)
Imprimer la page
The environment in which your weighing machine is used is very important. Air movement, temperature
changes, vibrations, direct sunlight, etc. all influence the performance of high precision weighing
machines. Therefore, place your weighing machine on a solid, sturdy surface that is free of air currents,
vibration and not in direct sunlight. The surface should not be magnetic and should be located away from
doors, windows, heaters, air conditioners and fans.
To summarize:
Put the weighing machine on a solid, firm and preferably vibration-proof, horizontal base
Make sure that the weighing machine cannot be shaken or knocked over
Protect from direct solar radiation
Avoid drafts and excessive temperature fluctuations
3.5 Checking the mains voltage
The following Safety recommendations must be observed when connecting the balance to the mains:
The balance may only be operated with the power adapter supplied.
Check before connecting the power adapter to the mains supply, that the operating voltage stated on the
power adapter agrees with the local mains voltage.
If the operating voltage is not the same as the mains voltage, the power adapter must on no account be
connected to the mains supply. Contact customer service.
3.6 Leveling the weighing machine
To function properly, the balance must be precisely horizontal. The balance is fitted with one bubble level
and adjustable feet for level-control, with the aid of which it is possible to compensate for small height
differences and / or any unevenness in the surface on which the balance is positioned.
The screw feet must be adjusted so that the air bubble is precisely in the center of the sight glass of the
bubble level (see Fig. 1)
Place the scale horizontally and keep the bubble inside the bubble level aligned with the red circle (See
Fig.1). In order to get exact measurements, the balance must again be carefully leveled after each
relocation.
Fig. 1 Correct leveling with the aid of the bubble level and adjusting feet.
Page 8 of 16
AL-manual-EC200-En-V2