Anyload EC200 운영 매뉴얼 - 페이지 8

{카테고리_이름} Anyload EC200에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anyload EC200 16 페이지.
Anyload EC200에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)

The environment in which your weighing machine is used is very important. Air movement, temperature

changes, vibrations, direct sunlight, etc. all influence the performance of high precision weighing

machines. Therefore, place your weighing machine on a solid, sturdy surface that is free of air currents,

vibration and not in direct sunlight. The surface should not be magnetic and should be located away from

doors, windows, heaters, air conditioners and fans.

To summarize:

 Put the weighing machine on a solid, firm and preferably vibration-proof, horizontal base



 Make sure that the weighing machine cannot be shaken or knocked over



 Protect from direct solar radiation



 Avoid drafts and excessive temperature fluctuations



3.5 Checking the mains voltage

The following Safety recommendations must be observed when connecting the balance to the mains:

The balance may only be operated with the power adapter supplied.

Check before connecting the power adapter to the mains supply, that the operating voltage stated on the

power adapter agrees with the local mains voltage.

If the operating voltage is not the same as the mains voltage, the power adapter must on no account be

connected to the mains supply. Contact customer service.

To function properly, the balance must be precisely horizontal. The balance is fitted with one bubble level

and adjustable feet for level-control, with the aid of which it is possible to compensate for small height

differences and / or any unevenness in the surface on which the balance is positioned.

The screw feet must be adjusted so that the air bubble is precisely in the center of the sight glass of the

bubble level (see Fig. 1)

Place the scale horizontally and keep the bubble inside the bubble level aligned with the red circle (See

Fig.1). In order to get exact measurements, the balance must again be carefully leveled after each

relocation.

Fig. 1 Correct leveling with the aid of the bubble level and adjusting feet.

Page 8 of 16

AL-manual-EC200-En-V2