Anywave ATSC VHF 100W Manuel de démarrage rapide - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Anywave ATSC VHF 100W. Anywave ATSC VHF 100W 17 pages.

11. (Optional Step) Navigate to the Exciter "SYSTEM" submenu and select

UPDATE under ADPC to run corrections. The exciter will then proceed through

4 stages of correction, computing Linear and Non-Linear corrections, and

automatically saving the coefficients into non-volatile memory upon

completion. The correction process typically takes from 8-10 minutes to

complete while real-time performance metrics of SNR and Shoulder

performance are displayed on the LCD.

12. Check RF Performance metrics (SNR, LIMD, UIMD) on the front panel screen

of the exciter, as well as on the PA's touchscreen.

Your TX should now be up and running properly into your load or on-air

antenna. Continue to monitor system parameters as you allow the transmitter to

operate and stabilize at full output power for another 30 minutes.

13. Navigate to the CAL setting under the AD3 Advanced submenu and select CAL

then press OK to calibrate the FWD PWR meter on the Exciter front panel to

100%.

14. To turn the TX On/Off, please use the RF On/OFF control in the RF submenu

of the exciter LCD or the exciter web interface. You may also use the TX

ON/OFF button on the PA's Home page, as shown below.

ACT-PAVIII1-QSG-DOC-V1.1, 06/26/2018

ATSC VHF 100W Quick Start Guide

Page 14 of 17