Anywave ATSC VHF 100W Manuel de démarrage rapide - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Anywave ATSC VHF 100W. Anywave ATSC VHF 100W 17 pages.

Imprimer la page
7. Continue to slowly raise the FWD power until you reach the full 100W, or your
desired TPO. Be careful to make small increases in the value of POWER as you
approach the desired output level.
8. Check the SNR and Shoulder (LIMD and UIMD) RF performance of your
system on the Exciter hi level status screen, as well as the exciter's pages on the
PA's touchscreen as shown below. Linear and Non-Linear corrections were
already performed and optimized at a TPO of 100W in the factory and so the
stored correction coefficients should produce good results.
ACT-PAVIII1-QSG-DOC-V1.1, 06/26/2018
ATSC VHF 100W Quick Start Guide
Page 12 of 17